427w / 538 Horsepower


Text Matt Direct 561-886-8456


Engine shown with optional serpentine belt system.

  • We start with a new 4-bolt main reinforced bare block

  • We install a new Ford Stroker steel crank shaft 4.170 stroke

  • H Steel Beam connecting rods 6.200" inch in Length
     with 190,000 psi ARP bolts

  • Power Forged SRP  10.5 to 1 Compression Flat Top Pistons

  • J & E Chrome Moly Rings

  • Heavy Duty Double Roller Comp Timing Set

  • Xtreme Energy Hydraulic Comp Roller Camshaft

  • Clevite H Series Bearings

  • Edelbrock Victor Jr. Aluminum Cylinder Heads

  • 2.05 X 1.60 stainless steel valves, hardened valve locks, chrome Moly retainers and HD Valve Springs

  • Comp Chrome Moly  pushrods

  • Comp Cams 1.6 Roller Rockers

  • New Melling High Volume Oil pump and screen

  • Complete Fel-Pro Performance Gasket set

  • New Harmonic Balancer SFI approved

  • New  Automatic Flexplate
    (Standard Transmission Steel Billet Flywheel SFI approved additional $300.00)

  • New Canton Large Capacity Oil pan and Aluminum Timing Cover

  • Polished Aluminum  Baffled Valve Covers

  • Edelbrock Victor Jr.Single Plane Intake

  • Holley 750 cfm Carburetor

  • New High Flow Aluminum Water pump 

  • New High Volume Fuel pump

  • Electronic MSD Ignition Distributor &  45,000 volt coil with Vacuum advance

  • New Champion Spark plugs gapped and installed

  •  8mm Accel Silicone Wires & Looms

  • New Thermostat Housing & Thermostat

  • 14" Air Cleaner

  • PCV Ventilation System

  • New Braided Stainless Fuel Lines and Gas Filter

  • Ignition Timing Set, Carburetor fully adjusted

  • Hot Run tested and dialed In place

  • Video Footage with engine running in our test Stand for your personal record

  • Packaged and Crated for Shipment




Engine comes standard with a 750 Holley Carburetor. MSD Fuel Injection is optional.

Alternator, Power Steering Pump and Air Conditioning Compressor are optional


International: 561-743-1879




Hit Counter